Sermorelin + GHRP-6 + GHRP-2 (aliases none on file) has 0 lab tests on file on Peptigrity from 0 shops and 0 laboratories, most recent none on file. Median reported purity none on file; 0 results compare measured to labelled quantity; 0 results report endotoxin. Price per mg is not published for blends. Peptigrity publishes measurements, not dosing advice. Figures as of 2026-09-18.

§ Fact sheet · generated from Peptigrity records · cite verbatim
Blends & Stacks

Sermorelin + GHRP-6 + GHRP-2 blend

3-peptide research blend in one vial: Sermorelin + GHRP-6 + GHRP-2. A triple GH stack pairing the GHRH analog Sermorelin with two ghrelin-mimetics — GHRP-6 (appetite-driving) and GHRP-2 (potent).

Awaiting blend-vial tests
3 peptides
Components · net content each
0 shops
Carrying this blend
Component-verified
Verified per component
What's actually in it

Composition

A blend has one whole-vial purity, but the number that decides what you're holding is the net content of each component — an HPLC run resolves a separate peak for each. So we verify Sermorelin + GHRP-6 + GHRP-2 component by component. Each links to its own compound page, where its full independent testing lives.

Typical Sermorelin + GHRP-6 + GHRP-2 formulation

ComponentTypical mgRole in the blendVerified purity
SermorelinvariesGHRH(1-29) analog — raises GH pulse amplitude99.4% · 225 testsView testing →
GHRP-6variesGhrelin mimetic — pulse frequency; strong appetite stimulation99.3% · 47 testsView testing →
GHRP-2variesGhrelin mimetic — pulse frequency + somatostatin suppression; potent99.2% · 38 testsView testing →
!

Composition varies by vendor. The components above are consistent across shops, but the milligrams and ratio are not — always dose by the individual component amounts printed on your vial, never by a generic “blend dose.”

The hard part

How you verify a blend

A blend is the single hardest product to trust — the whole-vial purity tells you the material is clean, but not whether every peptide is present in the right amount. Two questions decide that, and both are answerable in a lab.

01 · IDENTITY

Is every component actually present?

Mass spec (or a clean HPLC peak per compound) confirms each peptide is in the vial — not one short, not a cheaper substitute standing in for the expensive one.

02 · QUANTITY

Does each match the label?

Tested milligrams vs. labelled milligrams, per component. This is where blends fail quietly — one component underdosed to pad margin while the vial still “contains” everything.

Blend-vial lab tests

Sermorelin + GHRP-6 + GHRP-2 tested as a vial

Tests run on a Sermorelin + GHRP-6 + GHRP-2 vial as sold — broken down per component. This is the data no shop and no competitor publishes.

No Sermorelin + GHRP-6 + GHRP-2 vials tested yet.

Sermorelin + GHRP-6 + GHRP-2 is new to the library. Have a COA for a Sermorelin + GHRP-6 + GHRP-2 vial? Add it — every submission maps back to the 3 component compounds automatically.

Component testing

Verified purity of each ingredient

Until more Sermorelin + GHRP-6 + GHRP-2 vials are tested, the strongest signal is how each component performs in single-compound testing across the shops we track. Tap any card for its full data.

The full picture

About Sermorelin + GHRP-6 + GHRP-2

Last Updated: August 2026

Last Updated: August 2026

This triple stack layers Sermorelin (GHRH analog) with two GHRPs — GHRP-6 and GHRP-2. None of the three components is an approved product, and the combination is research-use-only. Sermorelin was formerly FDA-approved as Geref in two forms — a diagnostic agent (NDA 019863, 1990) and a pediatric growth-hormone-deficiency treatment (NDA 020443, 1997) — both discontinued in 2008 for commercial reasons; the FDA determined in 2013 that Geref was not withdrawn for reasons of safety or effectiveness, and sermorelin is today available only through compounding. Neither GHRP-6 nor GHRP-2 was ever approved for therapeutic use; both remain in Category 2 of the FDA's bulk-drug-substances evaluation (the 503B outsourcing-facility route), were not among the twelve peptides removed from Category 2 in April 2026, and are not on the Category 1 list eligible for compounding, as of August 2026. In sport, all three are prohibited at all times by the World Anti-Doping Agency under Section S2.2.4 (growth-hormone-releasing factors and secretagogues).

Why combine Sermorelin with two GHRPs?

Sermorelin provides the GHRH amplitude base, and adding two ghrelin-mimetics is intended to push the frequency/somatostatin-suppression side harder — GHRP-6 (strong appetite stimulation) and GHRP-2 (more potent, mild cortisol/prolactin) — for a fuller GH stimulus; the trade-off is that stacking two GHRPs compounds their receptor effects and adds variables. No controlled clinical trial of the Sermorelin + GHRP-6 + GHRP-2 blend has been published as of August 2026; stacking a GHRH analog with two different ghrelin mimetics compounds their receptor effects and adds variables, and the case for it is a mechanistic rationale, not a clinically-validated combined outcome.

What's the status, and how does Peptigrity verify?

The combination is not an approved product and is research-use-only; verify each labeled component's identity and purity via HPLC and mass-spec. Peptigrity collects independent third-party Certificates of Analysis for Sermorelin + GHRP-6 + GHRP-2 from shops' official channels and verifies each for authenticity before publishing. Because shops choose which COAs to publish, results reflect the batches shops have made public rather than every production batch — a selection bias we state openly. A community-funded Testing Grant to purchase and test vials anonymously is in development. Tests in the database come from independent labs such as Janoshik Analytical, Freedom Diagnostics, and Chromate. The shop trust score weights lab purity and reviews equally (50/50). See how to read lab results.

Educational information only; not medical advice. This is a research-use-only stack, not an approved therapy. Consult a qualified healthcare provider. Peptigrity does not sell, endorse, or recommend products or vendors.

Dose it right

Reconstitute & measure a blend

In a blend you can only set the dose of one component — the rest follow the fixed ratio. Our calculator does that math so you don't underdose the peptide you actually care about.

Blend calculator

Enter each component's milligrams and your BAC water — get per-component units for one syringe draw.

Open the blend calculator →

Reconstitution basics

How much bacteriostatic water, mixing without shaking, storage, and shelf life once mixed.

Read the reconstitution guide →
Related blends

Other stacks in the library

Questions

Sermorelin + GHRP-6 + GHRP-2, answered

Why use both GHRP-6 and GHRP-2?+

They're both ghrelin-mimetics with different profiles — GHRP-6 drives appetite, GHRP-2 is more potent — layered on a Sermorelin base.

Is stacking two GHRPs better?+

Not necessarily — it compounds their receptor effects and adds variables, and the triple stack isn't a clinically-validated product.

Is it legal or approved?+

No — research-market material is RUO and components are banned in sport (WADA). Verify local rules.

Does Peptigrity recommend a dose?+

No. Peptigrity is an independent review platform, not a medical authority.

For research and educational purposes only. Not medical advice. The peptides in this blend are investigational compounds not approved by the FDA for human use, and several are prohibited by WADA. Peptigrity is an independent review platform — we don't sell, endorse, or recommend specific products or vendors. Always consult a qualified healthcare provider.